ASTM WK70851
New Practice for Standard Practice for the On-Site Inspection of Installed Spray-Applied Fire Resistive Materials
1. Scope
This Practice provides a standard set of guidelines for conducting and reporting on inspections of installed Spray-Applied Fire Resistive Materials (SFRMs) applied to structural steel or other substrates. This Practice establishes procedures to inspect products and systems, including methods for field verification and inspection. This Practice addresses all types of Spray-Applied Fire Resistive Materials applied to structural steel and other substrates. This Practice provides an inspector, employed by an inspection agency, various methods to verify that required Spray-Applied Fire Resistive Materials and Coatings have been installed to the tested and listed system and manufacturers installation instructions in addition to project requirements.Keywords
Inspections, Inspection Agency, density, cohesion, adhesion, bond strength, thickness, fireproofing, fire protection, fire resistive materials, E1513, structural membersRationale
Currently, there is no document that has been produced in the industry that is a consensus of the fireproofing industry manufacturers and contractors. The ASTM Standard proposed creates that key document that has been developed by manufacturers, contractors AND those inspection agencies that provide fireproofing inspections. ASTMs new document will provide in mandatory code acceptable language the method to inspect SFRM Fireproofing Systems. Architects will specify this standard as the inspections are mandated by Chapter 17 of the International Building Code.
Work Item Status
Date Initiated: 12-02-2019
Technical Contact: Philip Mancuso
Item: 002
Ballot: E06.21 (20-02)
Status: Will Reballot Item
Item: 001
Ballot: E06.21 (21-02)
Status: Will Reballot Item
Item: 011
Ballot: E06.21 (23-01)
Status: Will Reballot Item
Item: 003
Ballot: E06 (23-06)
Status: Will Reballot Item
Item: 007
Ballot: E06 (24-03)
Status: Negative Votes Need Resolution